MIL-DTL-10215M
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as
specified in the contract or order (see 6.2). When packaging of materiel is to be performed by
DoD or in-house contractor personnel, these personnel need to contact the responsible packaging
activity to ascertain packaging requirements. Packaging requirements are maintained by the
Inventory Control Point s packaging activities within the Military Service or Defense Agency, or
within the military service s system commands. Packaging data retrieval is available from the
managing Military Department s or Defense Agency s automated packaging files, CD-ROM
products, or by contacting the responsible packaging activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful,
but is not mandatory.)
6.1 Intended use. The speedometers, tachometers, flexible shaft assemblies, flexible shaft
assembly cores and adapters covered by this specification are intended for use in indicating speed in
miles per hour or engine speed in revolutions per minute, and to record total distance in miles
traveled by the vehicle or total hours of operation of the engine.
6.1.1 Military unique. The speedometers, tachometers, and related parts covered by this
specification are intended for use in military motor vehicles. These devices may be subjected to a
variety of environments and severe conditions including vibration, shock, saltwater submersion,
and temperature extremes.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a.
Title, number and date of this specification.
b.
Painting, if other than as specified (see 3.5).
c.
d.
Identification and marking, if other than as specified (see 3.6).
e.
Inspection conditions, if other than specified (see 4.2).
f.
Standard specimens, if other than specified (see 4.2.2).
g.
Sampling plan, if other than specified (see 4.4.1).
h.
Packaging requirements (see 5.1).
6.3 Qualification. With respect to products requiring qualification, awards will be made
only for products which are, at the time of award of contract, qualified for inclusion in QPL-10215
whether or not such products have actually been listed by that date. The attention of the contractors
is called to these requirements, and manufacturers are urged to arrange to have the products that
they propose to offer to the Federal Government tested for qualification in order that they may be
eligible to be awarded contracts or orders for the products covered by this specification.
Information pertaining to qualification of products may be obtained from Defense Supply Center
Richmond, Attn: DSCR-VEB, 8000 Jefferson Davis Highway, Richmond, VA 23297-5616 or via
email at STDZNMGT@dla.mil.
18
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business